How To Use Eye Drops

                   Eye drops usually contain saline as a base ingredient. Depending on their intended use, they may also contain lubricating, tear-replacing (artificial tears), antiredness, and other substances, as well as medications.

Procedure To Use Eye Drops
(Using a mirror or having someone else give you the eyedrops may make this procedure easier.)
1. Wash your hands thoroughly with soap and water.
2. Check the dropper tip to make sure that it is not chipped or cracked.
3. Avoid touching the dropper tip against your eye or anything else - eyedrops and droppers must be kept clean.
4. While tilting your head back, pull down the lower
lid of your eye with your index finger to
form a pocket.
5. Hold the dropper (tip down) with the other hand, as close to the eye as possible without
touching it.
6. Brace the remaining fingers of that hand against your face.

Related Article :




7. While looking up, gently squeeze the dropper so that a single drop falls into the pocket made by the lower eyelid. Remove your index finger from the lower eyelid.
8. Close your eye for 2 to 3 minutes and tip your head down as though looking at the floor. Try not to blink or squeeze your eyelids.
9. Place a finger on the tear duct and apply gentle pressure.
10. Wipe any excess liquid from your face with a tissue.
11. If you are to use more than one drop in the same eye, wait at least 5 minutes
before instilling the next drop.
12. Replace and tighten the cap on the dropper bottle. Do not wipe or rinse the
dropper tip.
13. Wash your hands to remove any medication.

References
1. http://www.safemedication.com/
2. http://www.webmd.com/eye-health/eyedrops-an-ocean-of-uses
3. www.challaeyecare.com

Related Article :
-  Improve Eyesight

Post a Comment

Previous Post Next Post